Regarding the implementation standard of waste gas emission for biomass hot blast stove project, strict standards for air pollution emission of biomass briquette fuel in combustion process are put forward: "The emission standard of gas should be required" for biomass briquette fuel to reduce air pollution as far as possible. As far as development potential is concerned, biomass hot-blast stoves can alleviate the severe national conditions of our country and contribute to the realization of energy diversification. Its benefits and prospects are obvious to all of us. We welcome people with lofty ideals to join our biomass hot-blast stoves manufacturer to contribute to energy conservation and emission reduction of our country. 1、气体排放标准
1. Gas Emission Standards
According to expert analysis, the biomass fuel hot blast stove can achieve zero CO2 emission, micro-emission of NOx, SO2 emission less than 33.6 mg/m3, and smoke emission less than 46 mg/m3. Compared with coal-fired and oil-fired hot blast stoves, its pollution index is very low. According to the national emission control index of air pollutants, the emission standard of hot blast stove is SO2 < 100mg/m3 and smoke < 100mg/m3. Therefore, the emission standard of biomass hot blast stove meets the control index, and the emission concentration is far below the national standard.
2. Solid emissions
In addition to discharging gases, the biomass hot blast stove also discharges solids, the main component of which is ash after combustion. Fuel contains about 70% fiber content, less than 1/10 of carbon content, sulfur and chlorine content are less than 0.07%, nitrogen content is less than 0.5%, so the solid ash content is relatively low, which meets the national emission standards.
3. The pollutant control requirements of a single power-generating hot-blast stove with over 65 t/h output and using biomass fuels such as bagasse, sawdust and bark are implemented in accordance with the emission standards for atmospheric pollutants in thermal power plants (GB13223-2003).
4. The maximum allowable emission concentration of air pollutants from a coal-fired hot-blast stove with a single output of 65 t/h or less, which uses biomass fuels such as bagasse, sawdust and bark, is executed in accordance with the "Standard for Discharge of Air Pollutants from Hot-blast Stove" (GB13271-2001).
5. Where there are local emission standards which are stricter than the national standards, the local emission standards shall be implemented.
6. On the premise of meeting the emission standards of our country, the emission limits of the imported combustion equipment projects should meet the design and operation requirements of the imported equipment supporting pollution control facilities.
Dacheng Hot Blast Furnace, as the best producer of biomass environmental protection hot blast stove, knows that biomass briquette fuel has the characteristics of stable combustion, high efficiency, convenient storage and transportation, and is the best clean energy. Up to now, the ash produced by BMF combustion is about 1.5% of the fuel in the combustion equipment of biomass hot blast stove. Compared with the traditional coal-burning method, the reduction of pollution emission can be said to be several times higher. At the same time, the materials used in its combustion are also degradable wood, corn stalk, wheat straw and other natural substances, which can not only prevent land damage caused by direct in-situ combustion, but also make the best use of its resources. In addition, in order to facilitate ash removal, the rear of biomass hot blast stove is usually equipped with screw slag discharger, which can realize continuous ash removal.
标签:   铝艺大门 铝艺大门厂家 铝艺护栏 常州铝艺大门 常州铝艺护栏 热风炉