公司立足常州地区经营产品涵盖铝艺围墙护栏、锌钢企业护栏、各式铝艺阳台护栏、铝艺大门、铝艺楼梯扶手、门窗系统,车库门、新型阳光房等多领域。

示例图片三
网站首页 > 新闻资讯 > 业界资讯

厂家解读热风炉的检修安全方法

2018-11-17 10:04:53 常州市星火铝艺制品有限公司 阅读

下面为大家介绍热风炉成都收账检修安全方法。首先,检修热风炉时,应用盲板或其他可靠成都找人公司切断装置防止煤气从邻近煤气管道窜入,并严格执行操作牌制度;煤气防护人员应在现场监护。其次,进行热风炉内部检修、清理时,应遵守下列规定;

The following is to introduce the hot stove repair safety methods. First, when the hot air stove is overhauled, the blind board or other reliable cutting devices are used to prevent the gas from channeling from the adjacent gas pipeline, and the operating card system is strictly enforced; the gas protection personnel should be monitored on the spot.

Secondly, the following regulations should be observed when the internal maintenance and cleaning of hot blast stoves are carried out.

1、煤气管道应用盲板隔绝,除烟道阀常州铝艺大门成都收账所有阀门应关死,并切断阀门电源;

1. Gas pipeline shall be insulated by blind plates. All valves except flue valves shall be closed and the power supply of the valves shall be cut off.

2、炉内应通风良好,一氧化碳浓度应在24ppm以下,含氧量应在18%~21%(体积浓度)之间,每2h应分析一次气体成分。

2, the furnace should be well ventilated, carbon monoxide concentration should be below 24ppm, oxygen content should be between 18% and 21% (volume concentration), each 2H should be analyzed a gas composition.

3、修补热风炉隔墙时,应用钢材支撑好隔棚,防止上部砖脱落。

3. When repairing the partition wall of hot blast stove, steel should be used to support the partition shed to prevent the upper brick from falling off.

最后,热风管内部检修时,应打开人孔,严防煤气热风窜入。

Finally, the manhole should be opened when the hot air pipe is repaired, and the gas hot air should be strictly prevented.

以上是热风炉收账检修安全方法介绍。欢迎您前来选购我们成都找人公司产品!

The above is the introduction of the safety methods for the maintenance of hot blast stove. Welcome you to come and buy our products! 



标签:   常州铝艺大门 铝艺大门 铝艺大门厂家 铝艺护栏 常州铝艺护栏 热风炉